Gigabyte 8S648FXP-RZ-C user manual Install AGP Card, Install I/O Peripherals Cables

Step 3: Install AGP Card

1.Read the relate AGP card's instruction document before install the AGP card into the computer.

2.If your AGP card has "AGP 4X/8X(1.5V) notch"(show below), please make sure your AGP card is AGP 4X/8X(1.5V).

AGP 4X/8X notch

3.Please carefully pull out the small white-drawable bar at the end of the AGP slot when you try to install/uninstall the AGP card. Please align the AGP card to the onboard AGP slot and press firmly down on the slot. Make sure your AGP card is locked by the small white-drawable bar.

Step 4: Install I/O Peripherals Cables

Step 4-1: I/O Back Panel Introduction

*

PS/2 Keyboard and PS/2 Mouse connector

To install a PS/2 port keyboard and mouse, plug the mouse to the upper port (green) and the keyboard to the lower port (purple).

Parallel port (LPT)

The parallel port allows connection of a printer, scanner and other peripheral devices.

Serial port (COMA/COMB)

Mouse and modem etc. can be connected to Serial port.

USB port

Before you connect your device(s) into USB connector(s), please make sure your device(s) such as USB keyboard, mouse, scanner, zip, speaker...etc. Have a standard USB interface. Also make sure your OS supports USB controller. If your OS does not support USB controller, please contact OS vendor for possible patch or driver upgrade. For more information please contact your OS or device(s) vendors.

"*" Only for 8S648FXP-RZ.

English

- 11 - Hardware Installation Process