ATTO Technology S-Class Maintenance Commands, FcScsiBusyStatus, MaxEnclTempAlrm, MinEnclTempAlrm

FcScsiBusyStatus

You may set the Diamond to report busy or queue full when it is unable to accept the command.

Default: Busy

Set syntax: set FcScsiBusyStatus [busyqfull]

FirmwareRestart

Causes a warm restart of the Diamond Storage Array.

Immediate command: FirmwareRestart

MaxEnclTempAlrm

Sets/displays the maximum enclosure temperature alarm of the Diamond Storage Array in degrees Celsius. Valid entries are between 5 and 52 degrees and above the current minimum enclosure temperature alarm.

Default: 47

Set syntax: set MaxEnclTempAlrm [5-52]

Requires a SaveConfiguration command

Get syntax: get MaxEnclTempAlrm

MinEnclTempAlrm

Sets/displays the minimum enclosure temperature alarm of the Diamond Storage Array in degrees Celsius.Valid entries are between 5 and 47 degrees and below the current maximum enclosure temperature alarm

Default: 5

Set syntax: set MinEnclTempAlrm [5-47]

Requires a SaveConfiguration command

Get syntax: get MinEnclTempAlrm

Temperature

Returns the current internal temperature of this Diamond Storage Array in degrees Celsius. The value is read only.

Get syntax: get Temperature

Zmodem

Use the Zmodem protocol to transfer a file to or from the Diamond Storage Array. The filename is required if the send option is specified.Available only through the RS- 232 interface

CAUTION

After a firmware image is downloaded to the Diamond Storage Array, the image is placed into flash memory. During this time (about 90 seconds), DO NOT remove power to the Diamond Storage Array or the flash may become corrupted. Power should not be removed until the READY prompt appears.

Immediate command: Zmodem [Send filename Receive]

Requires a FirmwareRestart