5.5.6 Diagnostic Commands
AudibleAlarm
Enables or disables the audible alarm in the Diamond Storage Array. When enabled, an alarm will sound when the Fault LED on the front panel blinks.
Default: disabled
Set syntax: set AudibleAlarm [enabled disabled]
Get syntax: get AudibleAlarm
DiamondModel
Returns specific Diamond Storage Array model information including firmware release and date.
Get syntax: get DiamondModel
DiamondName
Used to identify this Diamond over its Fibre Channel and Ethernet networks. You may customize the name of each Diamond Storage Array enclosure to distinguish it from other units. Maximum eight characters.
Set syntax: set DiamondName [name]
Requires a SaveConfiguration command
Get syntax: get DiamondName
DriveCopyStatus
Displays the status of a DriveCopy or DriveWipe operation
Immediate command: DriveCopyStatus
DriveInfo
Displays information about all disk drives or detailed information about a specific disk drive. Detailed information about an individual drive is obtained by supplying a drive identifier. For output examples, refer to Information Commands Results on page ii.
Immediate command: DriveInfo [sled ID] [drive ID]
FcNodeName
Returns the Fibre Channel node name stored in NVRAM for this Fibre Channel port: the same as the World Wide Name for port 0.
Get syntax: get FcNodeName
FcPortList
Lists the status of all available Fibre Channel ports.
Immediate command: FcPortList
FcPortName
Returns the Fibre Channel port name stored in NVRAM for this Fibre Channel port.
Get syntax: get FcPortName [port number]
Help
Displays a list of available commands. Type help followed by a command name to display detailed
Immediate command: Help [Command Name]
IdentifyDiamond
Enable this option to identify the current Diamond Storage Array. The fault LED on its front panel will blink. Disable to cancel the ‘blink code.’
Set syntax: set IdentifyDiamond [enableddisabled]
Get syntax: get IdentifyDiamond
Info
Displays version numbers and other key information about the Diamond Storage Array including data rate, connection mode, WorldWideName, Diamond Storage Array name.
Immediate command: Info [all]
LUNInfo
Displays information about all LUNs (logical unit numbers) or detailed information about a specific LUN. Do not specify a LUN to get information about all LUNs. Specify a LUN to get detailed information about that individual LUN.
Immediate command: LUNInfo [LUN]
SerialNumber
View the serial board number, a
Get syntax: get SerialNumber
41
ATTO Technology Inc. Diamond Storage Array Installation and Operation Manual