McDATA 3000 manual Loading Starting Diagnostic Program Exit and Reboot

13

Diagnostics

Loading and

Starting the

Diagnostic Program

Exit and Reboot

Use the following procedure to load and start the diagnostic program:

1.From the prom> prompt, type dll_load “diags/xxxx.dll” and press the Enter key.

where xxxx=acht (CHARM ATM/POS diagnostic program) sbtt (PowerPC diagnostic program)

fcbb (Fibre Channel diagnostic program) acht (CHARM ATM/POS diagnostic program e10t (Ethernet diagnostic program)

gbit (Gigabit Ethernet diagnostic program) zpct (Compression diagnostic program) isbt (Flash Memory diagnostic program)

The UltraNet Edge 3000 will display the size of the program and the loading process.

Example:dll_load “diags/sbtt.dll” Enter value: -1=0xffffffff=int_pri_ptr + 0xfe00d47

2.From the prom> prompt, type start_ xxxx and press the Enter key.

where xxxx=acht (CHARM ATM/POS diagnostic program) sbtt (PowerPC diagnostic program)

fcbb (Fibre Channel diagnostic program)

acht (CHARM ATM/POS diagnostic program) e10t (Ethernet diagnostic program)

gbit (Gigabit Ethernet diagnostic program) zpct (Compression diagnostic program) isbt (Flash Memory diagnostic program)

To exit the diagnostic program and reboot, use the following procedure:

1.At the program menu, type 0 and press the Enter key.

The UltraNet Edge 3000 will now perform an autoboot sequence.

NOTE: To reboot while at the prom> prompt, type reset and press the Enter key.

13-18 McDATA UltraNet Edge 3000 User Guide