McDATA 3000 manual Xix

Preface

Appendix B, Installation and Cabling, provides information regarding the installation process, including instructions for connecting the network cables to the UltraNet Edge 3000.

Appendix C, Serial Cables and Adapters, lists the RS-232 cables, the DB connectors, and the pinouts for the DB connectors available through McDATA. It also contains cable and connector specifications for the Fibre Channel, 10/100 Ethernet, Gigabit Ethernet, and ATM/POS OC-3 interfaces.

Appendix D, Advanced UCM Configurations, provides additional UltraNet ConfigManager (UCM) configuration options that are beyond the typical Edge network configurations. The topics covered are; Configuring the Internal McDATA Fibre Channel Switch Interface, Time Synchronization Protocol, Transport CRC Checking, E_Port Disk Streaming Settings, and F_Port Disk Streaming Settings.

Appendix E, Static Routes, describes how to display, verify, add, and modify static routes.

Appendix F, Configure SNMP, provides an overview for configuring SNMP on the UltraNet Edge 3000.

Appendix G, Resetting the System to Factory Default, provides the procedure for resetting the system to the factory settings using the sysclean command.

Appendix H, Manual Configuration of the Initial IP Settings, provides the procedures for the initial configuration of the IP settings if UltraNet ConfigManager is not used.

Appendix I, Using the Set Spantree Portfast Command on Cisco Routers, provides information about the spantree portfast command for Cisco routers.

Appendix J, Configuration Worksheets, provides worksheets to aid in network configuration.

NOTE: The customer is responsible for ensuring conformance with power and specifications provided in this guide, for ensuring adherence to federal, state, and local building and electrical codes, for providing and installing communication cables on other vendors’ equipment, and for providing a storage area.

Preface

xix