McDATA 3000 manual Fibre Channel Interface Card Removal Procedure

Fibre Channel Interface Card Removal Procedure

CAUTION

Make sure the power is off. Attach a wrist strap and follow ESD procedures during the handling of all electronic components.

NOTE: When placing the top cover onto the chassis, ensure the fan wires and DC wires are clear of the UltraNet Edge 3000 chassis. This is to prevent any pinched wires.

1.Attach the UltraNet Edge 3000 top cover to the UltraNet Edge 3000 by pressing the cover into place and then sliding the cover forward so that it fully covers the top of the front brace bracket.

2.Secure the cover using the four screws that were made available during the removal procedure. Torque to 6 in-lbs.

3.Reconnect the power cords (rear).

4.Turn on the power supplies.

Fibre Channel Interface Card Removal Procedure

Use the following procedure to remove the Fibre Channel (FCBB) interface card from the UltraNet Edge 3000.

Tools required: A small Phillips screwdriver and an adjustable

Torque driver, rated between 3 and 15 in-lbs.

CAUTION

Attach a wrist strap and follow ESD procedures during the handling of all electronic components.

1.Follow the Top Cover Removal Procedure.

2.Turn off both power supplies on the UltraNet Edge 3000.

3.Unplug the power cords.

4.Locate the Fibre Channel interface card.

The Fibre Channel interface card is located on the front right side of the UltraNet Edge 3000 and can occupy I/O 1 and I/O 2 (see illustration below).

Hardware Maintenance 12-9

12