7
Configuring a 1x1 ATM Wide Area Network
NOTE: If you are using the ATM WAN Configuration Worksheet from Appendix J for a 1x1 or 2x1 configuration, enter the IP Management address labeled 
for Node20.
For a 2x2 or 1x2 configuration, enter the IP Management address labeled 
for Node20.
The IP address must be different than the Ethernet Maintenance
Interface address.
15.Click Next>.
The ATM Circuit Wizard - Configure Circuit dialog box appears.
This dialog box enables you to configure the circuit properties.
16.To enable the Adaptive Rate Limiting feature, check the Minimum box, and specify the minimum transmission rate. The minimum transmission rate should be set to 92% of the guaranteed minimum line rate, and should be less than or equal to the maximum line rate.
17.Check the Set MTR box, and specify the maximum transmission rate. The maximum transmission rate should be set to 92% of the speed of the slowest network segment.
Adaptive Rate Limiting uses the minimum and maximum trasnmission rates to dynamically determine bandwidth allocation. If a minimum transmission rate is not set, or if it is set
McDATA UltraNet Edge 3000 User Guide | |
|
|
