McDATA 3000 manual Click Next

Configuring a 2x2 Ethernet Wide Area Network

NOTE: Use I/O port 3 for all 1x1 configurations. When configuring a 2x2, use I/O port 3 to connect the first circuit and I/O port 4 for the second circuit.

The IP Circuit Wizard Node10 Configure Interface dialog box appears.

This dialog box enables you to configure the IP WAN interface properties for Node10.

7.Enter the IP Address (IP WAN address) and the Subnet Mask.

The IP WAN address must be different from the Ethernet maintenance interface address.

NOTE: If you are using the Configuration IP Address Worksheet from Appendix J, enter the following information:

For Node10, enter the IP address labeled for the circuit on a 1x1 or 2x1 configuration or the 1st circuit of a 2x2 or 1x2.

For the 2nd circuit of a 2x2 or 1x2 configuration, enter the IP address labeled

.

8.Click Next>.

The IP Circuit Wizard Node10 Configure Gateway dialog box appears.

The gateway IP address entered in this dialog box will be the router IP WAN address attached to the UltraNet Edge 3000 (Node10).

Configuring an F_Port Extension over an Ethernet WAN 6-15

6