McDATA 3000 manual Enter the Maximum Burst Size cells/sec in this field

Configuring a 1x1 ATM Wide Area Network

cells/sec) are valid enabled values. This value matches the value specified in the Peak Cell Rate field. This field is only selectable if VBR is selected as the Quality of Service type. If UBR or CBR is selected as the Quality of Service type, this field is grayed out and cannot be configured.

h.Enter the Maximum Burst Size (cells/sec) in this field.

0 through 2812 (cells/sec) are valid enabled values. The default value is 0 (cells/sec). This field is only selectable if VBR is selected as the Quality of Service type. If UBR or CBR is selected as the Quality of Service type, this field is grayed out and cannot be configured.

i.Click Next>.

The ATM Circuit Wizard - Node20 - Configure IP Mgmt dialog box appears.

This dialog box configures the IP Management link over this circuit. Configuring IP Management over the ATM circuit is optional.

14.To configure IP Management over this circuit, check Set, enter the IP Address, and the Subnet Mask.

Configuring an E_Port Extension over an ATM WAN 7-21

7