McDATA 3000 manual 11-7

Request License Key

from Technical

Support

Obtain Current

Version of UltraNet

ConfigManager

Power Down the

UltraNet Edge 3000

Unit

Replace the UltraNet

Edge 3000 Chassis

and Update UCM

Upgrading the UltraNet Edge 3000 Software

4.<blue>Replace the UltraNet Edge 3000 Chassis and Update UCM

5.<blue>FTP the New UltraNet Edge 3000 Software

6.<blue>Install the New UltraNet Edge 3000 Software

7.<blue>Deliver the Configurations

When an UltraNet Edge 3000 chassis is replaced, McDATA Technical Support will need to create a License Key for the new hardware replacement. The License Key is based on the serial number of the new unit and feature functionality that was originally ordered with the unit.

Obtain the most current version of UltraNet ConfigManager (UCM) from McDATA and install it on the Windows PC used to configure the network.

Use the following procedure to power down the UltraNet Edge 3000:

1.Direct the on-site technician to power off the UltraNet Edge 3000 that is being replaced.

2.Direct the on-site technician to remove all cabling.

3.Direct the on-site technician to remove all applicable interface cards.

4.Direct the on-site technician to remove the unit.

Use the following procedure to replace the new UltraNet Edge 3000 chassis and update UCM:

1.Direct the on-site technician to replace the old unit with the new UltraNet Edge 3000 chassis.

2.Direct the on-site technician to replace all cabling.

3.Direct the on-site technician to replace all applicable interface cards.

4.Direct the on-site technician to power on the unit.

5.Using terminal emulation, dial into the new UltraNet Edge 3000.

6.Issue the setNetCfg command to configure the Ethernet maintenance interface IP host address, default gateway, and subnet mask.

7.Issue the reset command to reboot the UltraNet Edge 3000.

Product Support and Software Maintenance 11-7

11