7
Delivering the Configured Network
Delivering the Configured Network
Now that you have configured a sample network, or if you made changes to the configuration parameters, you must deliver the configuration information for each node defined on the active network map to the actual nodes.
The configuration information can be delivered in two different ways, File>Deliver Network or File>Delivery Wizard.
The configurations can be delivered via the Maintenance Port IP or the PPP Port IP. If you do not have direct IP connectivity, use the PPP option. See “Setting the Delivery Properties” below.
NOTE: If you used the “Manual Configuration of the Initial IP Settings” procedure in Appendix H, complete the “Update UltraNet ConfigManager with the Manual Configurations” procedure before delivering the configured network.
Setting the Delivery | To set the properties for delivery of the network map configurations, | |
Properties | use the following procedure: |
|
| 1. | , then select Properties. |
The Node10 Properties (UltraNet Edge 3000) screen appears.
T
2.Click on the
The Delivery Interface defines the IP address by which the network map will be delivered.
3.Select the desired option to deliver the network map (configurations) to the node(s).
4.Click OK.
McDATA UltraNet Edge 3000 User Guide | |
|
|
