McDATA 3000 manual Click Next

8

Configuring a 1x1 Ethernet Wide Area Network

NOTE: If you do not know what the default gateway (the router IP address attached to the UltraNet Edge 3000) is at this point, you can add the static route at a later time. To add static routes at a later time, see Appendix E, Modifying Static Routes.

15.Check Set, enter the IP Address of the router directly attached to Node20 to set the static route.

NOTE: If you are using the Configuration IP Address Worksheet, enter the following information:

For Node20, enter the gateway address labeled for the circuit on a 1x1 or 2x1 configuration or the 1st circuit of a 1x2 or 2x2.

For the 2nd circuit of a 1x2 or 2x2 configuration, enter the gateway address labeled .

16.Click Next>.

The IP Circuit Wizard Configure Circuit dialog box appears. This dialog box enables you to configure the circuit properties.

8-18 McDATA UltraNet Edge 3000 User Guide