McDATA 3000 manual Flathead Undercut Screws Bracket Ear

UltraNet Edge 3000 Placement

—For a recessed mount, position the brackets so they are extended from the front of the UltraNet Edge 3000 unit approximately 3 1/4”. Attach the brackets using the rear holes (see illustration below).

6-32 Flathead Undercut Screws (8)

Bracket Ear (2)

Sb082

NOTE: Using a screw longer than 1/4 inch will impinge on the power supply and make it impossible to remove.

2.Position the UltraNet Edge 3000 unit in the rack. It may be necessary to tilt the unit approximately six inches or so to clear the rack mounting rails (a 4U opening is needed to accomplish this).

Approximately

6”

10-32 Screws

Sb083

Equipment Rack

Mounting Rails

3.Using a #2 Phillips screwdriver and four screws (two for each bracket) designed for the rack, attach the UltraNet Edge 3000 with the bracket ears to the equipment rack.

B-3