McDATA 3000 manual Ethernet 10/100, Removing Fibre Channel Cabling Fibre Channel Transceivers

Network Interface Connections

Removing Fibre Channel Cabling

Fibre Channel Transceivers

The following illustration shows a fiber optic cable with a LC connector and a fiber optic transceiver.

1. Grasp the LC connector at the end of the fiber optic cable.

Fiber Optic

Transceiver

Fiber Optic

Cable

LC Connector Clip Sb128

2.Depress the LC connector clip located underneath the LC connector before pulling to remove the cable from the I/O.

The Fibre Channel connection uses the standard LC connector. The interface card uses either short wave (multi-mode) or long wave (single-mode) transceivers. (see Appendix C, Cables, Connectors, and Adapters for the specifications). Instructions for removing and installing the transceivers are found in Chapter 12, Hardware Maintenance.

Ethernet 10/100	This section provides cabling procedures for the 10/100 Ethernet
Cabling	interface. The interface comes standard with a short wave
	(multi-mode) transceiver. A long wave (single-mode) is not available
	for this interface type.
	1.	Locate the I/O interface configured as 10/100 Ethernet.
	2.	Locate the Ethernet cable with the RJ-45 connector.

Ze0088

3.Align the RJ-45 cable connector with the RJ-45 jack on the Ethernet card. Gently insert the connector.

B-8

UltraNet™ Edge Storage Router 3000 User Guide