Gigabit Ethernet Interface Card Removal Procedure

2.Secure the 10/100 Ethernet interface card using the two screws that were made available during the removal procedure. Torque to 6 in-lbs.

3.Reconnect the power cords (rear).

4.Turn on the power supplies.

5.Replace the cover by following the Top Cover Installation Procedure.

Use the following procedure to remove the Gigabit Ethernet (Gig-E) interface card from the UltraNet Edge 3000.

Tools required: A small Phillips screwdriver and an adjustable

Torque driver, rated between 3 and 15 in-lbs.

CAUTION

Attach a wrist strap and follow ESD procedures (see page B-19) during the handling of all electronic components.

1.Follow the Top Cover Removal Procedure.

2.Turn off both power supplies on the UltraNet Edge 3000.

3.Unplug the power cords.

4.Locate the Gig-E interface card.

The Gig-E interface card is located on the front left side of the UltraNet Edge 3000 and can occupy I/O 3 and I/O 4 (see illustration below).

5.Remove the two screws at the rear of the Gig-E interface card.

6.Carefully pull the Gig-E interface card up. The Gig-E interface card is connected to two socketed connectors.

7.Remove the Gig-E interface card from the chassis.

Hardware Maintenance	12-13

McDATA 3000 manual Gigabit Ethernet Interface Card Removal Procedure