McDATA 3000 manual Setting the Initial, Network Map Area

5

Configuring a 1x1 Ethernet Wide Area Network

Network Map Area

(Click here twice to place two nodes in the map)

	UltraNet ConfigManager automatically assigns a name and
	number to each icon that represents the UltraNet Edge 3000, for
	example Node10 and Node20. The node icons and their
	corresponding names are also displayed under the NetMap1
	heading in the TreeView Area on the left.
Setting the Initial	If you configured an UltraNet Edge 3000 custom chassis (in Chapter
Configuration	4), continue the configuration process with the “Setting the Initial
	Configuration” procedure.
	NOTE: When you are performing this part of the configuration, the PC
	which has UltraNet ConfigManager installed on it, must be attached to the
	same subnet as the UltraNet Edge 3000 Ethernet maintenance interface. If this
	is not possible, refer to the “Manual Configuration of the Initial IP Settings”
	procedure in Appendix H.
	1. Right click on Node10 and select Set Initial Config from the
	menu that appears.

5-6 McDATA UltraNet Edge 3000 User Guide