10/100 Ethernet Interface Card Removal Procedure
For I/O 1, the Fibre Channel interface card will plug into location J14 and J15 on the motherboard. If the Fibre Channel interface card is being installed into I/O 2, plug it into location J12 and J13 on the motherboard.
2.Secure the Fibre Channel interface card using the two screws that were made available during the removal procedure. Torque to 6
3.Reconnect the power cords (rear).
4.Turn on the power supplies.
5.Replace the cover by following the Top Cover Installation Procedure.
NOTE: To replace the Fibre Channel transceiver, see the replacement procedures found later in this chapter.
10/100 Ethernet Interface Card Removal Procedure
Use the following procedure to remove the 10/100 Ethernet interface card from the UltraNet Edge 3000.
Tools required: A small Phillips screwdriver and an adjustable
Torque driver, rated between 3 and 15
CAUTION
Attach a wrist strap and follow ESD procedures (see page
1.Follow the Top Cover Removal Procedure.
2.Turn off both power supplies on the UltraNet Edge 3000.
3.Unplug the power cords.
4.Locate the 10/100 Ethernet interface card.
The 10/100 Ethernet interface card is located on the front left side of the UltraNet Edge 3000 and can occupy I/O 3 and I/O 4 (see illustration below).
5.Remove the two screws at the rear of the 10/100 Ethernet interface card.
Hardware Maintenance | |
|
|
12
