Replacing the Fibre Channel Short Wave Transceiver
Replacing the Fibre Channel Short Wave Transceiver
This section provides procedures for both removing and installing the various types of Fibre Channel short wave transceivers.
The following procedures apply to the FCBB interface card except where otherwise noted.
Tools required: No special tools are required.
CAUTION
Attach a wrist strap and follow ESD procedures during the handling of all electronic components.
The transceivers are hot swappable, which means they can be replaced while the UltraNet Edge 3000 unit is in operation.
|
|
|
| CAUTION |
| ||
|
|
|
| Laser radiation is invisible and can damage the eye. | |||
|
|
|
| Unterminated optical connectors may emit laser radiation. | |||
|
|
|
| Do not view the beam with the naked eye or with optical | |||
|
|
|
| instruments. Dust caps and dust covers MUST be left in | |||
|
|
|
| place on all unterminated bulkhead receptacles and on the | |||
|
|
|
| end of every radiating fiber jumper. | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Removing the Fibre |
| Use the removal procedure below that corresponds with the type of | |||||
Channel Short Wave |
| transceiver you are removing. | |||||
SFP Transceiver |
|
|
|
|
|
| |
Removing the Black |
|
|
|
|
|
| |
| NOTE: This black metal clasp transceiver is also used with the FCXL2 | ||||||
Metal Clasp |
| interface card. | |||||
Transceiver |
|
|
|
|
|
| |
| 1. Remove the fiber optic cabling from the transceiver. | ||||||
|
|
| |||||
|
|
| 2. Lift the black metal clasp up and carefully pull to release the | ||||
|
|
| transceiver from the interface card. | ||||
Hardware Maintenance | |
|
|
12
