11
Upgrading the UltraNet Edge 3000 Software
| Verify your Current |
| Before upgrading your software, use the following procedure to | ||
| Software Version |
| verify the current version of software from your PC: | ||
|
| 1. | Telnet to the UltraNet Edge 3000. | ||
|
| 2. | Enter the correct password if previously defined. | ||
|
| 3. | Issue the following commands to verify the current software | ||
|
|
|
| versions: | |
|
|
|
| tm.0x00> rpm query | |
|
|
| The current versions of all the software packages will be displayed. | ||
|
|
| Below is an example of how the version information is displayed. | ||
|
|
|
| ||
|
|
|
| ||
|
|
|
| ||
|
|
|
| ||
|
|
| The first three modules listed in the example above show the current | ||
|
|
| version for the UltraNet Edge 3000 OS. The last module listed shows | ||
|
|
| the current version of WebView. | ||
|
|
|
|
| |
| Upgrading the |
| This section explains all of the steps required to replace the chassis | ||
| UltraNet Edge 3000 - |
| and upgrade your UltraNet Edge 3000 to the most current software | ||
|
|
| version. This procedure is applicable when initiated by | ||
|
|
| McDATA field personnel. | ||
|
|
|
|
| |
|
|
| NOTE: This upgrade procedure only applies to UltraNet Edges currently at | ||
|
|
| version 3.1.1.1 or higher. Both UltraNet Edge 3000 units must be local. | ||
|
|
|
|
| |
|
|
| There are several short procedures required for upgrading the | ||
|
|
| UltraNet Edge 3000 in a local environment. Follow the steps | ||
|
|
| summarized below: | ||
|
| 1. | Request License Key from Technical Support | ||
|
| 2. | Obtain Current Version of UltraNet ConfigManager | ||
|
| 3. | Power Down the UltraNet Edge 3000 Unit | ||
|
| 4. | Replace the UltraNet Edge 3000 Chassis and Update UCM | ||
|
| 5. | FTP the New UltraNet Edge 3000 Software | ||
| McDATA UltraNet Edge 3000 User Guide | ||||
|
|
|
|
|
|
