Fibre Channel Interface Card Installation Procedure

5.Remove the two screws at the rear of the Fibre Channel interface card.

6.Carefully pull the Fibre Channel interface card up. It is connected to two socketed connectors.

7.Remove the Fibre Channel interface card from the chassis.

8.Follow the Fibre Channel Interface Card Installation Procedure to install a new Fibre Channel interface card.

Fibre Channel

Interface CardScrew (2) (1 Gigabit or 2 Gigabit)

I/O 4	I/O 3	Sb112

I/O 2	I/O 1

Use the following procedure to install the Fibre Channel (FCBB) interface card into the UltraNet Edge 3000 chassis.

Tools required: A small Phillips screwdriver and an adjustable

Torque driver, rated between 3 and 15 in-lbs.

CAUTION

Make sure the power is off. Attach a wrist strap and follow ESD procedures during the handling of all electronic components.

1.Carefully insert the Fibre Channel interface card in either I/O 1 or I/O 2.

12-10	McDATA UltraNet Edge 3000 User Guide

McDATA 3000 manual Fibre Channel Interface Card Installation Procedure