McDATA manual Building a Custom Edge 3000 Chassis

Building the Custom Chassis

UltraNet ConfigManager automatically assigns a name and number to each icon that represents the UltraNet Edge 3000, for example Node10 and Node20.

The node icons and their corresponding names are also displayed under the NetMap1 heading in the TreeView Area on the left.

16.Continue configuring the Network Map by using the appropriate chapter for the type of network you are configuring, beginning with the “Setting the Initial Configuration” section:

—If you are configuring an implementation using E_port extension over an Ethernet WAN, use Chapter 5, Configuring an E_Port Extension over an Ethernet WAN as an example.

—If you are configuring an implementation using F_port over an Ethernet WAN, use Chapter 6, Configuring an F_Port Extension over an Ethernet WAN as an example.

—If you are configuring an implementation using E_port extension over an ATM WAN, use Chapter 7, Configuring an E_Port Extension over an ATM WAN as an example.

—If you are configuring an implementation using FICON extension over an Ethernet WAN, use Chapter 8, Configuring FICON Extension as an example.

—If you are configuring a FC/SCSI Tape Pipelining implementation, use Chapter 9, Configuring Tape Device Extension as an example.

Building a Custom Edge 3000 Chassis 4-7

4