McDATA manual McDATA UltraNet Edge 3000 User Guide

7

Configuring a 1x1 ATM Wide Area Network

5.Select either Dedicated Circuit, Fail Over, or Load Balancing in the Network Routing Options. For more information on these routing options, see the “Network Routing Options” section in Chapter 3.

•If you are creating a 1x1 configuration, the only selectable routing type is Dedicated Circuit. All other options in this dialog box are grayed out and ignored.

•The options selectable from this dialog box are limited by the license key for the node. If the license key does not provide support for the Fail Over and Load Balancing network routing types, only the Dedicated Circuit network routing type is selectable, and all other options on this dialog are grayed out.

•If you have not entered the licensing information for each node in the circuit using the License Wizard, only the Dedicated Circuit network routing type is selectable from this dialog box.

•If you want to change the Network Routing Type after you have created the data paths, double-click the F/C interface on the Network Map. Click the Network button at the bottom of the F/C interface dialog box (FC10 - Node10) and select the Network Routing Type. You do not need to create the data paths again to change the Network Routing Type.

6.Click Next.

7-26 McDATA UltraNet Edge 3000 User Guide