5.Replace the cover by following the Top Cover Installation Procedure.
NOTE: To replace the Gigabit Ethernet transceiver, see the replacement procedures found later in this chapter.
OC-3 ATM Interface Card Removal Procedure
Use the following procedure to remove the
Tools required: A small Phillips screwdriver and an adjustable
Torque driver, rated between 3 and 15
CAUTION
Attach a wrist strap and follow ESD procedures (see page
1.Follow the Top Cover Removal Procedure.
2.Turn off both power supplies on the UltraNet Edge 3000.
3.Unplug the power cords.
4.Locate the
The
5.Remove the two screws at the rear of the
6.Carefully pull the
7.Remove the
Hardware Maintenance | |
|
|
12
