McDATA 3000 manual Power Supply Removal Procedure

Power Supply Removal Procedure

1.Remove the new fan assembly from its antistatic wrapping.

2.Connect the power-feed connector(s) to the main processing board. (Each connector has one black and one red power-feed wire which are keyed and polarized.)

CAUTION

If you have not turned off the power to the unit, the fan blades will begin to rotate as soon as the power feed connectors/wires are connected.

3.Insert the hinge into the slot just to the left of the fan assembly cutout.

4.Swing the fan assembly to a closed position making certain that the screw lines up with the threaded screw hole.

CAUTION

As you swing the new fan assembly to a close position, make certain that the power-feed wires don’t become pinched.

5.Use a small straight-slot screwdriver to tighten the 6-32-inch flathead blade captive screw securing the fan assembly to the UltraNet Edge 3000.

6.If the UltraNet Edge 3000 was in a rack mount, replace the unit back in the equipment rack.

NOTE: Remember to turn the unit’s power on if you turned it off for the removal procedure.

Power Supply Removal Procedure

Use the following procedure to remove the power supply from the

UltraNet Edge 3000.

Tools Required: No special tools are required.

Hardware Maintenance 12-5

12