McDATA 3000 manual Click Next

5

Configuring a 1x1 Ethernet Wide Area Network

The IP WAN address must be different from the Ethernet maintenance interface address.

NOTE: If you are using the Configuration IP Address Worksheet, enter the following information:

For Node10, enter the IP address labeled for the circuit on a 1x1 or 2x1 configuration or the 1st circuit of a 1x2 or 2x2.

For the 2nd circuit of a 1x2 or 2x2 configuration, enter the IP address labeled

.

8.Click Next>.

The IP Circuit Wizard Node10 Configure Gateway dialog box appears.

The gateway IP address entered in this dialog box will be the router IP WAN address attached to the UltraNet Edge 3000 (Node10).

At this time you can configure the gateway address (the router IP WAN address attached to the UltraNet Edge 3000) to create a static route to the destination IP address (Node20 in this example) by continuing through the remainder of the steps in this procedure.

NOTE: If you do not know what the router IP address attached to the UltraNet Edge 3000 is at this point, you can add the static route at a later time. To add static routes at a later time, see Appendix E, Static Routes.

5-14 McDATA UltraNet Edge 3000 User Guide