McDATA 3000 manual Connecting the UltraNet Edge

Connecting the UltraNet Edge 3000

NOTE: Do not stack the units. The top air holes and side vents must remain unconstricted.

Connecting the UltraNet Edge 3000

This section describes the procedures for making your initial setup connection (Ethernet RJ-45), power connection, network interface connections, and maintenance/diagnostics connections.

Setup Connection This connection allows you to configure your UltraNet Edge 3000 using the UltraNet ConfigManager application.

1.Connect an Ethernet straight through Category 5 cable to the RJ-45 connector labeled Ethernet on the UltraNet Edge 3000 unit.

2.Connect the other end of the cable to the Ethernet network connection. The UltraNet Edge 3000 unit must be on the same subnet as the PC which has UltraNet ConfigManager installed on it (consult with your systems administrator for the location).

Front View

Power Supply Redundant Power Supply

Back View

Fan (4)

Figure B-1Connecting the CAT5 Cable to the UltraNet Edge 3000

Sb017

B-4

UltraNet™ Edge Storage Router 3000 User Guide