McDATA 3000 manual Configuration IP Address Worksheet will be used as examples

8

Configuring a 1x1 Ethernet Wide Area Network

		NOTE: For help on the configuration process, click the Help button on the
		active dialog box or press the F1 key.
Gathering the IP		Before starting the configuration procedure in ConfigManager you
Addresses		will need to gather the IP addresses for your network. The IP host
		addresses and the completed UltraNet Edge Storage Router
		Configuration IP Address Worksheet will be used as examples in the
		configuration process. The worksheet is referred to as the
		Configuration IP Address Worksheet throughout the remainder of this
		chapter.
		Figure 8-1 shows an example of a network configured with two
		UltraNet Edge 3000s as a 2x2 implementation.
192.168.101.4		IP Cloud		192.168.201.4
	Router/			Router/
	Switch			Switch
	Default				Default
	Gateway 1				Gateway 2
		Fibre	Fibre			Fibre	Fibre
		Channel	Channel			Channel	Channel
192.168.10.3		Switch	Switch	192.168.20.3		Switch	Switch
Maintenance IP				Maintenance IP
192.168.10.1				192.168.20.1
UltraNet Edge	192.168.100.1			UltraNet Edge	192.168.200.1
Storage Router	Ethernet WAN			Storage Router	Ethernet WAN
Node 10				Node 20

192.168.100.4	IP Cloud	192.168.200.4
			Router/
Router/		Sb039
Switch			Switch

Figure 8-1Sample FICON ISL with Ethernet WAN using two UltraNet Edge 3000s

Using the Configuration IP Address Worksheet in Appendix J to gather the IP addresses and associated subnet masks to configure each UltraNet Edge 3000.

You will need the following addresses:

8-2 McDATA UltraNet Edge 3000 User Guide