McDATA 3000 manual IP Circuit Wizard Introduction dialog box appears

8

Configuring a 1x1 Ethernet Wide Area Network

5.Right-click on Node 20 and then repeat step through step to set the licensing information for this node.

6.Continue the configuration process by proceeding to the “Adding an IP Circuit” procedure.

Adding an IP Circuit You will now create an IP circuit. A circuit is the IP WAN link between Node10 and Node20. Use the IP Circuit Wizard to create and configure the IP circuit by using the following procedure:

1. Select the Links tab on the center toolbar.

Links tab

IP icon (globe)

2.Click the IP icon on the center toolbar.

3.Click the first node to create an IP circuit (in this example, Node10).

This will cause “marching ants” to highlight the area around the node icon, indicating that the node is in a special configuration mode.

4.Click the second node (the destination that you want to connect the circuit to).

The IP Circuit Wizard Introduction dialog box appears.

8-12 McDATA UltraNet Edge 3000 User Guide