McDATA 3000 manual Field Description, Authentication Traps

4 — Warning condition

5 — Condition is normal but still significant

6 — Informational

7 — Debug-level messages

7.Set the Host Access section to the IP address of the network management machine.

a. Click the Asterisk (*) to select the Address field and enter a valid IP address.

b. Select the Action field and set to either Allow or Deny. (This will allow access to an individual IP address if the Default Action is set to Deny. See Table F-1 for a detailed description of these fields.)

8.Click OK.

9.Proceed to the “Delivering the Configured Network” section in the appropriate configuration chapter to deliver the configurations files.

NOTE: For more detailed information, see the UltraNet ConfigManager online Help.

Table F-1	SNMP Configuration Screen Fields
		Field	Description
		Authentication Traps	Yes enables the Authentication Traps to be sent to the defined
			trap destination.
			No disables the Authentication Traps.
		Default Action	This field defines the access rights for all the hosts that are not
			specified in the Host Access field in the lower portion of the
			screen. It acts as a default setting.
			Allow is the default. For example, if you set this field to Deny,
			all hosts will be denied access unless they are defined
			individually to Allow in the Host Access field below.
		Read Community	Specifies the Read Community. This field can hold up to 255
			alphanumeric characters and can be upper and lower case
			letters.

F-5