McDATA 3000 manual OC-3 ATM Interface Card Installation Procedure

12

OC-3 ATM Interface Card Installation Procedure

8.Follow the OC-3 ATM Interface Card Installation Procedure to install the new OC-3 ATM interface card.

Screw (2)

OC-3 Interface

Card

I/O 4 I/O 3 Sb114

I/O 2 I/O 1

OC-3 ATM Interface Card Installation Procedure

Use the following procedure to install the OC-3 ATM interface card into the UltraNet Edge 3000 chassis.

Tools required: A small Phillips screwdriver and an adjustable

Torque driver, rated between 3 and 15 in-lbs.

CAUTION

Make sure the power is off. Attach a wrist strap and follow ESD procedures (see page B-19) during the handling of all electronic components.

1.Carefully insert the OC-3 ATM interface card in I/O 3.

The OC-3 ATM interface card will plug into I/O 3, location J8 and J9 on the motherboard.

2.Secure the OC-3 ATM interface card using the two screws that were made available during the removal procedure. Torque to 6 in-lbs.

3.Reconnect the power cords (rear).

4.Turn on the power supplies.

5.Replace the cover by following the Top Cover Installation Procedure..

12-16 McDATA UltraNet Edge 3000 User Guide