McDATA 3000 Gathering the IP, Addresses, Configuration process. The worksheet is referred to as

Configuring Tape Device Extension

4. Setting the Initial Configuration

5. Setting the License Information

6. Adding an IP Circuit

7. Creating a Data Path for Fibre Channel Device Extension Interfaces

a. Optional Step: Static Mapping the LUNs and Filtering the Source WWN

	8. Delivering the Configured Network
	NOTE: Fibre Channel Switch Zoning, Static Edge LUN Mapping, and Source
	WWN Filtering may or may not be needed depending upon the type of
	network you are configuring. If Fibre Channel Switch Zoning is needed, do
	this step before using UCM to configure the Edge. See the sections, “Required
	Static Edge LUN Mapping” (page -5) and “Required Source WWN Filtering”
	(page -7) to determine if these steps are needed.
	There are three different examples shown in the “Network
	Configuration Examples” section, to be used as references to
	determine when Fibre Channel switch zoning, statically mapping the
	LUNs, and source WWN filtering are required.
	If your network requires static mapping or source WWN filtering,
	perform all the steps shown in the above list including the optional
	step “Static Mapping the LUNs and Filtering the Source WWN”.
	Perform the “Delivering the Configured Network” step last.
	NOTE: For help on the configuration process, click the Help button in UCM
	on the active dialog box or press the F1 key.
Gathering the IP	Before starting the configuration procedure in ConfigManager you
Addresses	will need to gather the IP addresses for your network. The IP host
	addresses and the completed UltraNet Edge Storage Router
	Configuration IP Address Worksheet from Appendix J will be used in
	the configuration process. The worksheet is referred to as the
	Configuration IP address Worksheet throughout the remainder of this
	chapter.
	You will need the following addresses:
	• UltraNet Edge 3000 Ethernet Maintenance Interface host IP
	address
		Configuring Tape Device Extension
			9-9

9