12
10/100 Ethernet Interface Card Installation Procedure
6.Carefully pull the 10/100 Ethernet interface card up. The 10/100 Ethernet interface card is connected to two socketed connectors.
7.Remove the 10/100 Ethernet interface card from the chassis.
8.Follow the 10/100 Ethernet Interface Card Installation Procedure to install the new 10/100 Ethernet interface card.
Screw (2)
10/100 Ethernet
Interface Card
I/O 4 | I/O 3 |
|
| Sb118 |
| I/O 2 |
| ||
|
| I/O 1 | ||
|
|
| ||
|
|
|
|
10/100 Ethernet Interface Card Installation Procedure
Use the following procedure to install the 10/100 Ethernet interface card into the UltraNet Edge 3000 chassis.
Tools required: A small Phillips screwdriver and an adjustable
Torque driver, rated between 3 and 15
CAUTION
Make sure the power is off. Attach a wrist strap and follow ESD procedures (see page
1.Carefully insert the 10/100 Ethernet interface card in either I/O 3 or I/O 4.
For I/O 3, the 10/100 Ethernet interface card will plug into location J8 and J9 on the motherboard. If the 10/100 Ethernet interface card is being installed into I/O 4, plug it into location J10 and J11 on the motherboard.
McDATA UltraNet Edge 3000 User Guide | |
|
|
