7
Configuring a 1x1 ATM Wide Area Network
Setting the Initial | If you configured an UltraNet Edge 3000 custom chassis (in Chapter | |
Configuration | 4), continue the configuration process with the “Setting the Initial | |
| Configuration” procedure. | |
|
|
|
| NOTE: When you are performing this part of the configuration, the PC | |
| which has UltraNet ConfigManager installed on it, must be attached to the | |
| same subnet as the UltraNet Edge Storage Router Ethernet maintenance | |
| interface. If this is not possible, refer to the “Manual Configuration of the Initial | |
| IP Settings” procedure, in Appendix H. | |
|
|
|
| 1. Right click on Node10 and select Set Initial Config from the | |
| menu that appears. | |
The Initial Network Setup dialog box appears. The detected
UltraNet Edge Storage Router will appear in the section labeled
RECEIVED UltraNet Configuration Requests.
McDATA UltraNet Edge 3000 User Guide | |
|
|
