McDATA 3000 manual Delivering the Configured Network

5

Delivering the Configured Network

The Network Map will appear and should look like this:

This completes the procedure for FC/IP data path mapping.

If you are configuring a 2x2, repeat the steps in both the “Adding an IP Circuit” and the “Creating a Data Path” sections.

Proceed to the “Delivering the Configured Network” section in this chapter.

Delivering the Configured Network

Now that you have configured a sample network, or if you made changes to the configuration parameters, you must deliver the configuration information for each node defined on the active network map to the actual nodes.

The configuration information can be delivered in two different ways, File>Deliver Network or File>Delivery Wizard.

The configurations can be delivered via the Maintenance Port IP or the PPP Port IP. If you do not have direct IP connectivity, use the PPP option. See “Setting the Delivery Properties” below.

Note: If you used the “Manual Configuration of the Initial IP Settings” procedure in Appendix H, complete the “Update UltraNet ConfigManager with the Manual Configurations” procedure before delivering the configured network.

5-24 McDATA UltraNet Edge 3000 User Guide