McDATA 3000 manual Gnic3 auto, Fccnt batchstat, Fccnt clear backbone, Clear batchstats, Clear ints

13

User Interface Commands for the UltraNet Edge 3000

	gnic3 auto	This command displays the auto negotiation parameters regarding
		the Gigabit Ethernet interfaces.
	FCCNT	The FCCNT user interface is used to display statistical and
		informational data pertaining to the FCBB Fibre Channel card.
		For further information on the fccnt user interface commands, refer to
		the FCCNT chapter in the UltraNet Edge Storage Router Command
		Reference. The following sections highlight the commands useful for
		troubleshooting.
	fccnt batch_stat	This command displays the counts of Fibre Channel frames in each
		batch as they are passed from the FCCNT driver to the transport.
	fccnt clear backbone	This command clears the backbone trace for one or all Fibre Channel
		instances.
	clear batch_stats	This command clears the interface batching statistics or one or all
		Fibre Channel instances.
	clear ints	This command clears the interface interrupt statistics or one or all
		Fibre Channel instances.
	clear stats	This command clears the interface statistics or one or all Fibre
		Channel instances.
	fccnt dump	This command displays the state of the Fibre Channel backbone for
	backbone	the FCCNT interface.
		tm.0x10> fccnt
		fccnt1.0x10> dump backbone
		Example of fccnt dump backbone screen display for a good connection:
		Backbone for instance 1 is bound using local LUA 0x20
		remote LUA 0x10
		to interface TankTrsp
		E_Port interface is in passthrough mode
		Flow control mode 2
		connection is up - READY
		batching mtu is - 16000
		optical speed is 2 Gbps
		flow control is OFF
			Revision Level 16
		NOTE: Passthrough mode indicates that you have a good E_port connection.
	McDATA UltraNet Edge 3000 User Guide
13-8