McDATA 3000 manual Power Supply Installation Procedure, Top Cover Removal Procedure

Power Supply Installation Procedure

Power Supply Installation Procedure

Use the following procedure to install the power supply into the

UltraNet Edge 3000.

CAUTION

Attach a wrist strap and follow ESD procedures during the handling of all electronic components.

Tools Required: No special tools are required.

CAUTION

Make sure power is turned off for the power supply that is being installed.

1.Remove the new power tray from the antistatic wrapping.

2.Place the power tray into the slot and gently slide it back until it is connected to the power distribution board at the back of the UltraNet Edge 3000.

3.Make certain the metal clip has snapped into place holding the power tray firmly in place.

4.Reconnect the power cords (rear).

5.Turn on the power supplies.

Top Cover Removal Procedure

Use the following procedure to remove the top cover from the

UltraNet Edge 3000.

Tools required: A small Phillips screwdriver.

CAUTION

Attach a wrist strap and follow ESD procedures during the handling of all electronic components.

Hardware Maintenance 12-7

12