McDATA 3000 manual Upgrading Edge, Software from, Or Higher

11

Upgrading the UltraNet Edge 3000 Software

6.After the tarExtract command is complete, issue a reset command to boot up the UltraNet Edge 3000.

NOTE: If you do not reset the UltraNet Edge 3000 after the tarExtract command is completed, the box will hang and the prom will be corrupted. This state is unrecoverable.

	7.	Remove any files that were renamed in step .
	8.	After issuing the reset command, press ENTER to go into prom
		mode.
	9.	Issue the flash_html “romx” command at the prom prompt.
	10.	Issue the reset command after the flash_html “romx” is
		complete.
	11.	Using Windows Dial-up Networking, establish a PPP session
		from the local PC to the UltraNet Edge 3000 that has just been
		upgraded.
Deliver the	Using UCM version 3.1.3, deliver the new configurations to the
Configurations	UltraNet Edge 3000 that has just been upgraded.
	The UltraNet Edge 3000 will be rebooted after a successful delivery.
Upgrading Edge	This procedure only applies to software upgrades and should not be
Software from	used when it is necessary to replace the chassis. Use the following
3.1.1.1 or Higher	procedure only when upgrading the Edge software from version
	3.1.1.1 or higher:
	1.	FTP the Edge 3.1.x.x software into the nodes that are being
		upgraded.
		Where xx = the most current version of UltraNet Edge 3000
		software.
	2.	Issue the upgrade EDR31xx.tar command (wait for system
		prompt to return).
		Where xx = the most current version of UltraNet Edge 3000
		software.
	3.	Issue the abort command to reboot the system.
	4.	Stop the boot process by pressing the ENTER key while it is still in
		prom mode.

11-10 McDATA UltraNet Edge 3000 User Guide