Configuring a 1x1 Ethernet Wide Area Network
9.Check Set, enter the IP Address of the router directly attached to the IP WAN interface of Node10 to set the static route.
NOTE: If you are using the Configuration IP Address Worksheet, enter the following information:
For Node10, enter the gateway address labeled 
for the circuit on a 1x1 or 2x1 configuration or the 1st circuit of a 1x2 or 2x2.
For the 2nd circuit of a 1x2 or 2x2 configuration, enter the gateway address labeled 
.
10.Click Next>.
The IP Circuit Wizard Node20 Choose Interface dialog box appears (Node20 is the destination node).
This
drop-down arrow
11.Click on the
12.Click Next>.
NOTE: Use I/O port 3 for all 1x1 configurations.
When configuring a 2x2, use I/O port 3 to connect the first circuit and I/O port 4 for the second circuit.
The IP Circuit Wizard Node20 Configure Interface dialog box appears.
Configuring an E_Port Extension over an Ethernet WAN | |
|
|
5
