McDATA 3000 manual Fan Assembly Installation Procedure

12

Fan Assembly Installation Procedure

2.Place the UltraNet Edge 3000 unit on a level surface so the back of the unit is facing you.

3.Using a small straight-slot screwdriver, loosen the 6-32-inch flathead blade captive screw on the louvered fan door until it springs open.

4.Pull the louvered fan door open until the door hinge disengages.

5.Place the fan assembly (the louvered fan door and fan unit) to the side.

6.Disconnect the power connector by lifting up on the plastic latch with a non-metallic tool to release the power connector (each connector has a black and a red wire). Then remove it from the main processing board.

Hinge Slot Latch

Hinge
Fan Door	Captive Screw	Sb012

7.Place the disabled fan assembly into an antistatic bag or onto the static mat.

8.Follow the Fan Assembly Installation Procedure to install a new fan assembly.

Fan Assembly Installation Procedure

Use the following procedure to install the fan assembly into the

UltraNet Edge 3000.

Tools Required: A small straight-slot screwdriver.

CAUTION

Attach a wrist strap and follow ESD procedures during the handling of all electronic components.

12-4 McDATA UltraNet Edge 3000 User Guide