McDATA manual Chapter Building a Custom Edge 3000 Chassis

Contents

	Load Balancing	3-9
	Fail Over	3-9
	Switch WWN Proxy	3-10
	E_Port Disk Streaming Network Recommendations	3-10
	Required Minimum Hardware for E_Port Disk Streaming	3-11
	E_Port Disk Streaming Compatibility Matrix	3-11
	Fibre Channel Frame Level CRC	3-12
	Frame Level CRC on the FCBB Card	3-12
	Frame Level CRC on the FCXL2 Card	3-12
	Fibre Channel End to End CRC	3-13
	Minimum Requirements for CRC	3-14
	Fibre Channel MTU Batching	3-14
Chapter 4	Building a Custom Edge 3000 Chassis
	Building the Custom Chassis	4-1
	Starting UltraNet ConfigManager	4-1
	Using the Custom Chassis Wizard	4-1
Chapter 5	Configuring an E_Port Extension over an Ethernet WAN
	Configuring a 1x1 Ethernet Wide Area Network	5-1
	Gathering the IP Addresses	5-2
	Starting UltraNet ConfigManager	5-3
	Adding Nodes for an Ethernet WAN Configuration	5-3
	Adding a Fibre Channel Interface	5-5
	Setting the Initial Configuration	5-6
	Setting the License Information	5-9
	Adding an IP Circuit	5-11
	Creating a Data Path	5-20
	Delivering the Configured Network	5-24
	Setting the Delivery Properties	5-25
	Delivery Wizard	5-26
	Deliver Network	5-28
	Viewing Logs	5-28
Chapter 6	Configuring an F_Port Extension over an Ethernet WAN
	Configuring a 2x2 Ethernet Wide Area Network	6-1
	Gathering the IP Addresses	6-2
	Starting UltraNet ConfigManager	6-3
	Adding Nodes for an Ethernet WAN Configuration	6-4
	Setting the Initial Configuration	6-7
	Setting the License Information	6-10

iv

UltraNet™ Edge Storage Router 3000 User Guide