Configuring a 1x1 ATM Wide Area Network
9.To configure IP Management over this circuit, check Set, enter the IP Address, and the Subnet Mask.
NOTE: If you are using the ATM WAN Configuration Worksheet from Appendix J for a 1x1 or 2x1 configuration, enter the IP Management address labeled 
for Node10.
For a 2x2 or 1x2 configuration, enter the IP Management address labeled 
for Node10.
The IP address must be different than the Ethernet Maintenance Interface address.
10.Click Next>.
The ATM Circuit Wizard - Node20 - Choose Interface dialog box appears (Node20 is the destination node).
This
Configuring an E_Port Extension over an ATM WAN | |
|
|
7
