McDATA 3000 manual UltraNet WebView Monitoring Application

UltraNet WebView Monitoring Application

5.Issue the tartoc <filename> command to display a listing of the files within the tar archive file you wish to extract.

6.Check the resulting list to see if any of the files within the tar archive already exist on the disk. If versions of the files within the tar archive already exist on the disk, check their size to see if they are larger than the versions in the tar archive.

7.If any files in the tar archive are larger than the corresponding files on the disk, proceed to step . If the files in the tar archive are smaller than the corresponding files on the disk, do one of the following:

—Rename the corresponding file(s) on the disk using the rename <file 1><file 2> command.

—Remove the corresponding file(s) on the disk using the remove <file> command.

8.Issue the tarExtract “vx_tar.tar”,0 command at the prom prompt. Wait for the prom prompt to return before proceeding to step .

9.After the tarExtract command is complete, issue a reset command to boot up the UltraNet Edge 3000.

10.Remove any files that were renamed in step .

11.Issue the flash_html “romx” command at the prom prompt.

12.Issue the reset command after the flash_html “romx” is complete.

UltraNet WebView Monitoring Application

UltraNet WebView is McDATA’s browser-based monitoring tool for the UltraNet product family. It provides the ability to monitor SNMP interface statistics and the status of the chassis on an individual node in an UltraNet storage network. UltraNet WebView provides McDATA node monitoring capabilities from any location in the world that has an internet connection plus security access to that node. It supports browser-based access to Java applications through an Ethernet maintenance interface and in-band browsing through a WAN port.

Product Support and Software Maintenance 11-11

11