McDATA 3000 manual IP Address of PC running UCM

Configuring a 1x1 Ethernet Wide Area Network

IP Address of PC running UCM

NOTE: The Serial Number is located on the front of the chassis and is used to identify the UltraNet Edge 3000.

4.Click Apply to enable the maintenance interface. UltraNet ConfigManager will load the IP address information into the UltraNet Edge 3000 and will reboot.

NOTE: Watch the UltraNet Edge Configuration Status box for allocated and assigned messages. These messages will only appear for a brief moment and will indicate if the unit is resetting and booting up.

When finished booting up, the letters PMA will display and remain in the Alphanumeric messages window until the network configuration is delivered. Delivery is performed after the configuration in UltraNet ConfigManager is completed.

NOTE: If a bootp message is not received within 45 seconds, you will get the following Warning message. Use the procedure to manually configure the Maintenance IP Port described in Appendix H.

Configuring FICON Extension 8-9

8