McDATA 3000 manual Click Next

6

Configuring a 2x2 Ethernet Wide Area Network

13.Enter the IP Address (IP WAN address) and the Subnet Mask.

The IP WAN address must be different from the Ethernet maintenance interface address.

NOTE: If you are using the Configuration IP Address Worksheet from Appendix J, enter the following information:

For Node20, enter the IP address labeled for the circuit on a 1x1 or 2x1 configuration or the 1st circuit of a 2x2 or 1x2.

For the 2nd circuit of a 2x2 or 1x2 configuration, enter the IP address labeled

.

14.Click Next>.

The IP Circuit Wizard Node20 Configure Gateway dialog box appears.

The gateway IP address entered in this dialog box will be the router IP address attached to the UltraNet Edge 3000 (Node20).

At this time you can configure the gateway address (the router IP address attached to the UltraNet Edge 3000) to create a static route to the destination IP address (Node10 in this example) by continuing through the remainder of the steps in this procedure.

6-18 McDATA UltraNet Edge 3000 User Guide