McDATA 3000 manual Gigabit Ethernet, Enapoll Nouflo Memcont

UltraNet Edge 3000 Diagnostic Programs

{Dest Adrs 000088004FEE 40000100 42000100 100000 110000 120000 }

{ Internal BUFFER_MEM MII 100_Mb }

{ENET#1:B#5/D#01:PCI#0: E0000000 Enet Adrs 000088005672 }

{Dest Adrs 000088005672 600000 800000 102000 112000 122000 }

{ Internal HOST_MEM 10BT 10_Mb }

{ENA_POLL NO_UFLO MEM_CONT }

{Ethernet F/D_MODE ENA_INT 1st_ENET_TX/RX 2nd_ENET_RX/TX }

	0.	Exit	Diagnostic	13.	P2P DDir Incr Pkt
	1.	Set Options		14.	P2P DDir Chained Pkts
	2.	Set Parameters		15.	TX Line Test
	3.	Loopback Test		16.	RX Line Test
	4.	Lpbk	Incr Byte Test	17.	TX Ln Incr Byte Test
	5.	Lpbk	Incr Packet Test	18.	RX Ln Incr Byte Test
	6.	Lpbk	Chained Pkt Test	19.	TX Ln Incr Pkt Test
	7.	Port	to Port Test	20.	RX Ln Incr Pkt Test
	8.	Port	Incr Byte Test	77.	Debug Utilities
	9.	Port	Incr Packet Test	96.	Run All P2P Tests
	10.	Port	Chained Pkt Test	97.	Run All TX Line Tsts
	11.	P2P Dual Dir Test		98.	Run All RX Line Tsts
	12.	P2P DDir Incr Byte		99.	Execute All Loopback
	-> 99
	Loopback		Test running...
	***** PASSED--- Loopback Test					passed = 1,
	failed =		0
	Lpbk Incr Byte Test running...
	***** PASSED--- Lpbk Incr Byte			Test		passed = 1,
	failed =		0
	Lpbk Incr Packet Test running...
	***** PASSED--- Lpbk Incr Packet Test					passed = 1,
	failed =		0
	Lpbk Chained Pkt Test running...
	***** PASSED--- Lpbk Chained Pkt Test					passed = 1,
	failed =		0
Gigabit Ethernet	The UltraNet Edge 3000 Gigabit Ethernet diagnostic program resides
Diagnostic Program	on the UltraNet Edge 3000’s flash drive as the file gbit.dll. Using the
(GBIT)	PROM interface, the file must be loaded into memory and executed
	from there.

This program tests the UltraNet Edge 3000’s on-board Gigabit Ethernet interface and verifies that it can perform memory transfer functions across the primary PCI bus and local memory. Test data can be looped back either internally or externally.

Troubleshooting and Diagnostics 13-25

13