McDATA manual McDATA UltraNet Edge 3000 User Guide

5

Configuring a 1x1 Ethernet Wide Area Network

•If you are creating a 1x1 configuration, the only selectable routing type is Dedicated Circuit. All other options in this dialog box are grayed out and ignored.

•The options selectable from this dialog box are limited by the license key for the node. If the license key does not provide support for the Fail Over and Load Balancing network routing types, only the Dedicated Circuit network routing type is selectable, and all other options on this dialog are grayed out.

•If you have not entered the licensing information for each node in the circuit using the License Wizard, only the Dedicated Circuit network routing type is selectable from this dialog box.

•If you want to change the Network Routing Type after you have created the data paths, double-click the F/C interface on the Network Map. Click the Network button at the bottom of the F/C interface dialog box (FC10 - Node10) and select the Network Routing Type. You do not need to create the data paths again to change the Network Routing Type.

The Create Data Path Wizard - Choose Data Path Options screen appears.

6.E_port Disk Streaming increases performance in networks that have a round trip latency greater than 10 ms. It moves data more efficiently than our standard E_port solution. To enable the E_port Disk Streaming feature, check the Enable Disk Streaming check box.

5-22 McDATA UltraNet Edge 3000 User Guide