McDATA 3000 manual For Node10, enter the gateway address labeled

Configuring Tape Device Extension

At this time you can configure the gateway address (the router IP WAN address attached to the UltraNet Edge 3000) to create a static route to the destination IP address (Node20 in this example) by continuing through the remainder of the steps in this procedure.

NOTE: If you do not know what the router IP address attached to the UltraNet Edge 3000 is at this point, you can add the static route at a later time. To add static routes at a later time, see Appendix A, Modifying Static Routes.

9.Select Set, enter the IP Address of the router directly attached to the IP WAN interface of Node10 to set the static route.

NOTE: If you are using the Configuration IP Address Worksheet, enter the following information:

For Node10, enter the gateway address labeled .

10.Click Next>.

The IP Circuit Wizard Node20 Choose Interface dialog box appears (Node20 is the destination node).

This drop-down menu displays the available IP interface providers in the UltraNet Edge 3000 box for Node20.

Configuring Tape Device Extension 9-21

9