McDATA 3000 manual Gigabit Ethernet Interface Card Installation Procedure

12

Gigabit Ethernet Interface Card Installation Procedure

8.Follow the Gigabit Ethernet Interface Card Installation Procedure to install the new Gig-E interface card.

Screw (2)

Gigabit Ethernet

Interface Card

I/O 4	I/O 3			Sb115
		I/O 2
			I/O 1

Gigabit Ethernet Interface Card Installation Procedure

Use the following procedure to install the Gigabit Ethernet (Gig-E) interface card into the UltraNet Edge 3000 chassis.

Tools required: A small Phillips screwdriver and an adjustable

Torque driver, rated between 3 and 15 in-lbs.

CAUTION

Make sure the power is off. Attach a wrist strap and follow ESD procedures (see page B-19) during the handling of all electronic components.

1.Carefully insert the Gig-E interface card in either I/O 3 or I/O 4.

For I/O 3, the Gig-E interface card will plug into location J8 and J9 on the motherboard. If the Gig-E interface card is being installed into I/O 4, plug it into location J10 and J11 on the motherboard.

2.Secure the Gig-E interface card using the two screws that were made available during the removal procedure. Torque to 6 in-lbs.

3.Reconnect the power cords (rear).

4.Turn on the power supplies.

12-14 McDATA UltraNet Edge 3000 User Guide