3Com 5000 ATM manual Functions, CB5000 show atm slot vcc all, CB5000 set atm slot ilmi pvc 0/16

Recovering from Problems 6-9

4Use the following command to display vcc parameters:

CB5000> show atm <slot> vcc all

Verify the following parameters settings:

■SIG is 0/5

■ILMI is 0/16

5If necessary, use the following command to reset the ILMI parameter:

CB5000> set atm <slot> ilmi pvc 0/16

ATM commands do not take effect until you reset the module. Use the DMM RESET MODULE command to enable any ATM parameter changes.

6If the SIG parameter is not set to 0/5, contact your network supplier to set the SIG parameter to 0/5 at the ATM switch.

7Record the final settings of your ATM signalling parameters before continuing.

Verifying LEC Use the following procedure to verify the functions of a LEC:

Functions

1Use the following command to display the configuration mode of the LEC:

CB5000> show bport_lec <slot.lec> configuration

■If the configuration mode is manual, check the command display to verify that the correct LES ATM Address is listed. The LES ATM Address of the LEC must match the LES ATM Address of the ELAN to which the LEC is assigned.

■If the configuration mode is automatic, check the command display to verify that the ELAN Name parameter is set to the ELAN Name required by the ATM switch.

Contact your ATM switch service representative to determine the correct LES ATM Address and ELAN Name setting.

2Check the command display in step 1 to verify that the Mode parameter for the LEC is set to Enabled.

If the Mode parameter is not set to Enabled, use the following command to reset the Mode parameter to Enabled:

CB5000> set bport_lec <slot.lec> mode enable