3Use the following command to display the LAN/E status of the LEC:
CB5000> show bport_lec <slot.lec> status
Check the indication of the Interface State parameter. The possible status indications are:
■Initial
■Configure
■Join
■Bus connect
■Operational
If the Interface State is Operational, the LEC and ATM parameters are configured correctly.
If there is any other indication, record the result and continue with the procedure.
4Check the command display in step 3 and record the Last Failure State parameter.
If the Last Failure State indicates:
■Configure — The ATM Backbone SwitchModule is having problems with the LECS. Contact your ATM switch service representative to verify the LECS configuration.
■Join — The ATM Backbone SwitchModule is having problems connecting with the LES. Contact your ATM switch service representative to verify the LES address and ELAN name and the operation of the BUS service provider.
■Bus Connect — Contact your ATM switch service representative to verify the operation of the BUS service provider.